How to build DC to DC Converter

August 4, 2010 - category: DC to DC converter


The circuit below is a DC to DC converter using a standard 12 VAC center tapped power transformer wired as a blocking oscillator. The circuit is not very efficient but will produce a high voltage usable for low power applications. The input battery voltage is raised by a factor of 10 across the transformer and further raised by a voltage tripler consisting of three capacitors and diodes connected to the high voltage side of the transformer. The circuit draws about 40 milliamps and should operate for about 200 hours on a couple of 'D' alkaline batteries. Higher voltages can be obtained by reducing the 4.7K bias resistor.

Circuit diagram

Circuit diagram

circuit from http://www.bowdenshobbycircuits.info/page4.htm#triple.gif

If you liked this page please consider sharing. Thanks!

Bookmark and Share

Previous and next post from DC to DC converter