873
FREE
circuits!

How to build Bass-treble tone control circuit

December 13, 2010 - category: Tone and volume control

Circuit diagram

Bass-treble tone control circuit-Circuit diagram

The LM1036 is a DC controlled tone (bass/treble), volume and balance circuit for stereo applications in car radio, TV and audio systems. An additional control input allows loudness compensation to be simply effected. Four control inputs provide control of the bass, treble, balance and volume functions through application of DC voltages from a remote control system or, alternatively, from four potentiometers which may be biased from a zener regulated supply provided on the circuit. Each tone response is defined by a single capacitor chosen to give the desired characteristic.

Features:

  • Wide supply voltage range, 9V to 16V
  • Large volume control range, 75 dB typical
  • Tone control, ±15 dB typical
  • Channel separation, 75 dB typical
  • Low distortion, 0.06% typical for an input level of 0.3 Vrms
  • High signal to noise, 80 dB typical for an input level of 0.3 Vrms
  • Few external components required

Note:

Vcc can be anything between 9V to 16V and the output capacitors are 10uF/25V electrolytic








author: Tasos Anagnwstou, tasoti@panafonet.gr
circuit from http://www.electronics-lab.com/

If you liked this page please consider sharing. Thanks!


Bookmark and Share

Previous and next post from Tone and volume control